Pearl Coating™ 17oz Sublimation Travel Mug

1. Remove the black plastic insert inside the travel mug by unscrewing the bottom clockwise. 
2. Design your image and print it out on sublimation paper with a sublimation ink printer. 
3. Tape imaged sublimation paper onto white stainless steel insert with the plastic insert removed 
4. Set the mug press at 365F for 45 seconds. If your press has an idle and press temperature setting, adjust the time accordingly
5.  Ensure mug press has reached temperature, Place the insert into your mug press. 
6.  Close Mug Press. 
7. Once pressing is done, open the mug press, and take the insert out of the press. Use gloves or heat resistant cloth to handle the hot insert 
8.  Peel sublimation paper off. and leave it to cool off completely.
9. Install the insert onto the travel mug, then screw the bottom on anti-clockwise.
   Caution: Metal Insert is extremely hot when in the mug press, do not handle with bare hands
   Note: Temperature and time settings are only a guide/starting point, some mug presses may

Press Temperature: 400°F | Time: 12-15 minutes (test in your oven for accurate time) | Peel: Hot

1. Remove plastic top and bottom before you proceed.
2. Tape imaged sublimation paper onto your mug. Place the image toward the mug.
3. Place & center product inside the shrink wrap.
4. Use a heat gun on a low setting to shrink the wrap to the contour of the product. Begin with the side away from the transfer first. Ensure the wrap only encases the sides of the product leaving the top and bottom open.
5. Ensure that you have set the correct temperature & time for your convection oven.
6. Place the mug into your convection oven and close the convection oven's door.
7. Once the time is done, peel the shrink sleeve with the sublimation paper immediately.
8. Dunk in warm water. Leave on the table to dry.