The information provided in the table for pressing sublimation blanks is intended as a general guideline. Users should conduct their own tests to determine the exact timing, pressure, and other settings that work best with their specific printers, presses, and materials, as these factors can vary widely.
| Surface | Press Time | Temp | Pressure | Tips/Comments |
|---|---|---|---|---|
| Ceramic Mugs | 150-210 seconds | 350-400° F | 40 psi (medium) | Mugs should be cooled down after transfer paper is removed in warm water or using a cooling plate. |
| Stainless Steel Tumblers | 60 - 90 seconds | 365° F / 185 C | 40 psi (medium) | Rotate tumbler 180 degrees and press again for a full wrap. |
| Polyester Fabric | 35-45 seconds | 400 - 410° F | 40 psi (medium) | Pre-press to eliminate moisture. Use tack spray and blow-out sheet to avoid ghosting. |
| Vapor Apparel | 45-55 seconds | 380°-390° F | 40 psi (medium) | See vaporapparel.com for tips on reducing press lines. |
| Polyester with Foam Backing (Koozie / Mousepad) | 45 seconds | 400° F | 40 psi (medium) | Look for a tight knit and high white point for more vibrant color. |
| Metal/iLumipix (HD Photo Panels) | 60 seconds | 400° F | 40 psi (medium) | Remove plastic coating before pressing. Use blow-out paper. |
| Metal (Other Brands) | 60 seconds | 375°-400° F | 40 psi (medium) | Time varies with manufacturer. Always consult for correct time and temp. |
| Glass or Ceramic Tiles | 300 - 720 seconds | 400° F | 40 psi (medium) | Time varies depending on tile type and size. Consult the manufacturer. |
| Fire Retardant Plastics | 40-75 seconds | 350 - 400° F | 40 psi (medium) | Remove plastic coating. Remove transfer paper immediately after pressing. |
| Hardboard | 60 seconds | 400° F | 40 psi (medium) | Remove plastic coating and press with the transfer paper on top. |
| Glass | 180 - 240 seconds | 360 - 400° F | 40 psi (medium) | Be careful not to put too much pressure on the glass. This can shatter it. |
| Felt | 60 seconds | 400° F | 30-40 psi (light/medium) | Felt can curl as it cools. Place a heavy object on the substrate immediately after pressing. |
| Marble | 120 seconds | 390° F | 40 psi (medium) | Peel transfer paper while hot. Wait for substrate to cool before attaching additional materials. |
| Vinyl or HTV | 15 - 30 seconds | 310° F | 40 psi (medium) | Make sure to remove the backing before pressing. Peel mask immediately after pressing. |
| Polyester Linen | 55 - 65 seconds | 385 - 425° F | 40 psi (medium) | Press with substrate facing up and transfer paper on top. |
| Wood | 60 seconds | 400° F | 40 psi (medium) | Remove any plastic coating. Press with the transfer on top. |